Blind / Roller Shutter Actuator with Travel Detection and Manual Operation, 4-fold, 230 V AC, MDRC
The 4-fold Blind/Roller Shutter Actuator is used to control independent 230 V AC drives, for positioning blinds, roller shutters, awnings and other shading products via KNX. The device can also be used, for example, to control doors, windows and ventilation flaps.
The travel times of the drives are automatically determined via end position detection and stored.
The output contacts are mechanically interlocked, so that voltage cannot be applied to both contacts at the same time.
The device does not require an auxiliary voltage.
The outputs can be directly controlled on the device using the manual push buttons. The LEDs on the front of the device signal the status of the outputs.
Individual outputs can be copied or exchanged to reduce the programming effort.
The Blind/Roller Shutter Actuator is a modular installation device for installation in the distribution board on 35 mm mounting rails. The connection to the KNX Bus is implemented via bus connection terminals.
- Bus Voltage: KNX Bus 21...32VDC
- Bus Current Consumption: Max 12mA
- Outputs Up/Down: 4
- Output Rated Voltage: 230 V AC (45...65 Hz)
- Output Rated Current: 6A
|Input voltage||KNX Bus (29VDC)|
|EAN||40 16779 69844|